[Meet monitor] Alarm Function
Written by Tecnico Internacional
Updated at November 18th, 2026

It can work in any of these 3 modes:
HOME MODE
It will be triggered only when it receives a technical alarm signal defined in HOME MODE (flood, smoke, or 24-hour protection zones in general).
SLEEP MODE
In addition to technical alarms, it will also be triggered when it receives an alarm signal from an intrusion detector in a certain area of the house defined in the SLEEP MODE.
This is the usual mode of operation when there are people in some part of the house (e.g. bedrooms) and you want to leave other areas protected (e.g. living room, kitchen, etc.).
OUT MODE
In addition to previous alarms, it will also be triggered when it receives an alarm signal from an intrusion detector in the home defined in the OUT MODE.
This is the usual mode of operation when no one is home.
Touch the icon
to arm the alarm system.
The sequence is as follows:
Select OUT MODE
When in
or
mode, touch the
The change will be made automatically after 100 seconds, to give you time to leave the protected zone without triggering the alarm.
The remaining exit time is displayed.

Once the time has elapsed, the monitor will return to the standby screen, displaying an icon indicating the current mode in the upper left corner.

Select SLEEP MODE (from OUT MODE)
While in mode
, touch the icon
.
A dialling pad will appear.

Enter the ALARM PIN number and touch the confirmation icon.
You can also enter the DURESS PIN, which will cause the alarm to be deactivated but will in turn send a duress warning to the concierges.

The change will be made automatically after 100 seconds to prevent the alarm from being triggered if you need to pass through the protected area.
The remaining exit time is displayed.
Once the time has elapsed, the monitor will return to the standby screen, displaying an indicator icon in the upper left corner.
Select SLEEP MODE OR OUT (from HOME MODE)
While in mode
, touch the icon
or ![]()
The change will be made automatically after 100 seconds to prevent the alarm from being triggered if you need to pass through the protected area.
The remaining exit time is displayed.

Once the time has elapsed, the monitor will return to the standby screen, displaying an indicator icon in the upper left corner.
NOTES:
You may have entered the protected zone before accessing the monitor to disarm the alarm. You have a few seconds to perform the disarming process before the alarm is triggered.
The default ALARM PIN is 1-2-3-4 and the DURESS PIN is 4-3-2-1. It can be changed to others of your choice as explained in the "ALARM PIN" section.
The exact functioning of the alarm system depends on the installation and configuration of the equipment by the installer. Contact the installation company.
Download Article